Motorcycle Alarm


Posted on Dec 27, 2012

The circuit board and switches must be protected from the elements. Dampness or condensation will cause malfunction. Without its terminal blocks, the board is small. Ideally, you should try to find a siren with enough spare space inside to accommodate it. Fit a 1-amp in-line fuse close to the power source. This protects the wiring. Instead of using a key-switch you can use a hidden switch; or you could use the normally closed contacts of a small relay. Wire the relay coil so that it is energized while the ignition is on. Then every time you turn the ignition off, the alarm will set itself.


Motorcycle Alarm
Click here to download the full size of the above Circuit.

Any number of normally open switches may be used. Fit the mercury switches so that they close when the steering is moved or when the bike is lifted off its side-stand or pushed forward off its centre-stand. Use micro-switches to protect removable panels a




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Signal Tracer
4 Watt Amplifier with preamplifier
80x32 LED matrix display
Low frequency divider
Bench top power supply
Audio Filter Analyzer
Strobe Light circuit
lm317 adjustable power supply electronic project
pic micro multiple servo motor
low voltage cutout for 12v sla
Speaker Microphone circuit diagrams
Beginning Embedded Electronics - 2
Gate automatic lamp circuit



Top