12v stroboscope 250 400v dc circuit


Posted on Feb 6, 2014

The stoboscope tube needs about 250-400V DC to operate. This aerial voltage is generated application simple voltage footfall up ambit congenital from transistors Q1, Q2 and agent T1. This ambit gives out about 230V AC voltage which is again rectified with afterlight arch U1 (must accept at atomic 400V voltage rating) and stored to the capital capac


12v stroboscope 250 400v dc circuit
Click here to download the full size of the above Circuit.

itor C1. I congenital my stroboscope from genitalia taken from old camera beam unit. This access gave me nice beam tube with reflector, activate agent and some of the capacitors (for archetype C1). Other genitalia were the one luying around. I acclimated some aberrant triac I begin in my for the triggering circuit, but any triac which can handle at atomic 1A and 400V should do the job well.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    low pass filter subwoofer
    0.1Hz to 10Hz RF reciever
    Stereo balance tester
    Data-based Load Pull Amplifier
    uhf tv pre amplifier
    Simple low power Inverter Circuit (12V DC to 230V or 110V AC) diagram using CD4047 and IRFZ44 power MOSFET
    PWM Generator
    Ridiculously Simple AVR AM Radio Transmitter
    Cooker notification circuit



    Top