40 segment led s meter


Posted on Feb 4, 2014

Provide your radio with a actual cord signal, again acclimatize the HIGH LEVEL pot to the beginning of anecdotic the aftermost LED (all LEDs on). Remove the arresting completely, again acclimatize the LOW LEVEL pot to the beginning of no LEDs illuminated. If your radios S-meter achievement is greater than 5 volts, you mau ambition to alter the HIG


40 segment led s meter
Click here to download the full size of the above Circuit.

H LEVEL pot with a 10K resistor, and accommodate pin 6 of the right-most 3914 with the cathode of a 6. 1 volt zener diode, pulled up to 13 volts with a 1K resistor. The anode should be affiliated to ground. You may use a college voltage zener if necessary. This agreement provides 10ma per LED segment. Change the ethics to the resistors and pots to change the drive accepted to the LEDs. R1=12. 5/I R2=25/I R3=37. 5/I R4=50/I area I = the adapted LED current




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Automatic Charger for Battery Hi-Fi Preamps
0-50V 1A power supply with CA3086
Auto-battery-alternator-monitor
Safe-constant-current-source
LCD thermometer
Audio Mini FM Receiver
simple FSK/AFSK Modulator
FX803 Signalling Processor
FM voice transmitter for Band 2 VHF
Dimming the Nixies
Phase indication by vectorscope
Audio remote control switch schematic
Construction of 50Watt 8Ω two-way Hi-Fi Speakers



Top