Audio Mixer based JFET 2N3819


Posted on Feb 5, 2014

As numerous or as few channels as are needed may be added to the mixer. Do this by just duplicating the input `sections` that are shown on the schematic design. An audio amplifier is an electronic amplifier that amplifies low-power audio signals (signals composed primarily of frequencies between 20 - 20 000 Hz, the human range of hearing) to a lev


Audio Mixer based JFET 2N3819
Click here to download the full size of the above Circuit.

el suitable for driving loudspeakers and is the final stage in a typical audio playback chain. The preceding stages in such a chain are low power audio amplifiers which perform tasks like pre-amplification, equalization, tone control, mixing/effects, or audio sources like record players, CD players, and cassette players. Most audio amplifiers require these low-level inputs to adhere to line levels. While the input signal to an audio amplifier may measure only a few hundred microwatts, its output may be tens, hundreds, or thousands of watts. More explanation about power audio amplifier can be found at wikipedia. org This is a video tutorial about how to a very simple audio amplifier based on the LM386 amplifier chip. It can be built for less than $20 (or might be less than $8 in some countries) and used to amplify any low level audio signal including a guitar, bass or mp3 player.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    15 Watt Amplifier
    Digital lighting controler PIC16F870
    Variable-strobe-light
    3.5 To 10Mhz Simple Superheterodyne Receiver
    bluetooth controlled relay
    inverter circuit
    12V Lamp flasher circuit
    Three circuits of preamp tone controls by NE5532
    Hot Tub Hack
    AIR-FILTER SENSOR FOR HOME-USED AIR CONDITIONERS
    About Area 50
    Homemade infrared automatic door controller circuit
    Available voltage booster 400Vp-p output



    Top