Digital Radar Speedometer Circuit


Posted on Feb 7, 2014

This circuit is use to Digital Radar Speedometer. It allows us to evaluate the speed of any object moving, especially cars and other vehicles. The speed is calculated in kilometers per hour (KPH). Its display has three digits. This radar works with the laser reflection. It sends laser radiation to the object and this object reflects the laser radi


Digital Radar Speedometer Circuit
Click here to download the full size of the above Circuit.

ation to the radar. To evaluate the speed of a vehicle, we must be in front of it. In other words, the vehicle must come in our direction. Here`s the figure of the circuit; The laser LED can send a spot of light to a distance of 90 m (295 ft). It`s very important that the distance range of the laser LED is 90 m, if not, the speed will not be calculated properly. The laser diode, which receives the light signal by the laser LED, must be able to detect the light which is same color as that emitted by the laser LED. The laser diode and the laser LED must be placed one beside the other. They are protected by a tinted pane. They must be placed at the front of the radar and point the outside. The radar is powered by a 9V battery and it has a SPST switch to control its power state. The display, or the speed indicator, is placed at the rear of the radar, just on the right of the overload LED indicator. All the logic components of the circuit must be of the 74AS series and TTL type. Because they have short time of response (less than 1. 7 ns) and have high frequency supports (more than 200 MHz). The radar can evaluate the speed of an object moving between 0 to 999 km/h. After this speed, the overload LED indicator will turn on and the "999" will still displayed. The radar displays the speed during 3 seconds, after this time, it displays "zero" (0).




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Stopwatch 0-99 seconds (MC14518B)
    Low-Drift High-Impedance JFET DC Voltmeter
    By single-phase active power factor correction (APFC) Make up three-phase APF
    pcb fabrication Feasibility Question and Advice on CAD software
    simple microphone preamplifier
    car audio amplifier using tda2003 ic
    Using OP37 preamp



    Top