Digital Remote Thermometer


Posted on Feb 5, 2014

This circuit is intended for precision centigrade temperature measurement, with a transmitter section converting to frequency the sensor`s output voltage, which is proportional to the measured temperature. The output frequency bursts are conveyed into the mains supply cables. The receiver section counts the bursts coming from mains supply and show


Digital Remote Thermometer
Click here to download the full size of the above Circuit.

s the counting on three 7-segment LED displays. The least significant digit displays tenths of degree and then a 00. 0 to 99. 9 °C range is obtained. Transmitter-receiver distance can reach hundred meters, provided both units are connected to the mains supply within the control of the same light-meter. IC1 is a precision centigrade temperature sensor with a linear output of 10mV/ °C driving IC2, a voltage-frequency converter. At its output pin (3), an input of 10mV is converted to 100Hz frequency pulses. Thus, for example, a temperature of 20 °C is converted by IC1 to 200mV and then by IC2 to 2KHz. Q1 is the driver of the power output transistor Q2, coupled to the mains supply by L1 and C7, C8. The frequency pulses coming from mains supply and safely insulated by C1, C2 & L1 are amplified by Q1; diodes D1 and D2 limiting peaks at its input. Pulses are filtered by C5, squared by IC1B, divided by 10 in IC2B and sent for the final count to the clock input of IC5. IC4 is the time-base generator: it provides reset pulses for IC1B and IC5 and enables latches and gate-time of IC5 at 1Hz frequency. It is driven by a 5Hz square wave obtained from 50Hz mains frequency picked-up from T1 secondary, squared by IC1C and divided by 10 in IC2A. IC5 drives the displays` cathodes via Q2, Q3 & Q4 at a multiplexing rate frequency fixed by C7. It drives also the 3 displays` paralleled anodes via the BCD-to-7 segment decoder IC6. Summing up,...




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

EEPROM DAC with DS interface
Simulated inductor
Bell 202 and CCITT V23 Compatible FSK Modem Circuit
Simplest RF Transmitter
Alternative Halogen Power Supply
The electric current of mode control of the average current measures the circuit design of the voltage transformer
integrated circuit How do I control a two 12VDC 10A motors using an Arduino
How should I wire up the circuit to connect a TSOP4838 (Radio Shack 276-64) infrared receiver to an Arduino
Straight and Cross Cable LAN
12V Fan Directly on 220V AC
Household appliances electric water heater temperature regulating circuit circuit
Simple delay lamp circuit 1



Top