High Voltage Power Supply for Geiger Tubes


Posted on Feb 6, 2014

These power supply circuits are generating 500 volts but they may be modified to supply a couple of hundred to nearly 1000 volts by changing the zener diodes. These circuits generate high voltages and can cause dangerous shocks! Do not build these devices unless you are experienced and qualified to work on high voltage devices The difference is su


High Voltage Power Supply for Geiger Tubes
Click here to download the full size of the above Circuit.

btle; the feedback signal increases the voltage on the base of the 2N4403 to stop the oscillator instead of stealing current from the capacitor on the emitter. The result is much lower power dissipation when there is little or no load on the high voltage. The new circuit draws less than 1/2 mA when operating at 9 volts without a load using a 1:1 600 ohm audio isolation transformer. The 3 volt circuit may be modified in the same way but make sure to switch to a MPSA18 (or a similar very high gain transistor). The 120 volt zeners are also an improvement over trying to grade ordinary diodes; grading is just too much trouble! A 1N5273A is a typical type to try. Remember, this circuit can only supply a few microamperes so an ordinary 10 megohm voltmeter will load the output too much. (500 volts/10 megohms = 50 uA. ) With some transformers and zeners, the circuit will work better if the 10 megohm resistor is moved up to be in series with the diodes (see next schematic). It is a good idea to add a resistor in series with the diodes anyway, perhaps 100 k, to prevent damage when probing around. When operating properly, the current should drop down to below 1/2 mA with no load. The series 10 megohm resistor will make gas discharge devices work well in place of the zeners, too (neon bulbs, for example). Also try a. 1 uF capacitor from base to emitter of the MPSA18. This capacitor modification combined with the series 10 megohm allowed...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Stepper Motor controller with HC11
    smart amp delay
    TA8136S Radio Control Transmitter Ic - Toshiba Semiconductor
    2Digit up/down Counter
    Inductance feedback oscillator circuit



    Top