TV Relative Signal Strength Meter PCB

Posted on Feb 6, 2014

Circuit This circuit was designed to assist the installation of TV antennas. The signal is monitored using a small portable TV set and this circuit monitors the output of the TV`s FM detector IC via a shielded lead. To initially calibrate the meter, adjust trimpot VR2 to zero the meter. Trimpot VR1 is a sensitivity control and can be set for a pre

TV Relative Signal Strength Meter PCB
Click here to download the full size of the above Circuit.

set reading (ie, 0dB) or can be calibrated in millivolts. Rotating the antenna for a minimum reading on the meter (indicating FM quieting) gives the optimum orientation for the antenna.

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    600 watt audio amplifier (LM4702)
    High speed warning device
    Active Antenna I
    Ne602 Direct Conversion Receiver Circuit
    Accu charger use a diac and triac Schematic Diagram
    Optoelectronic circuits
    Line Follower Robot
    Moduler Preamplifier Circuit
    Designing The Low-Cost Mobile PC
    water alarm schematic
    John C. BEDINI free energy Motor/Generator
    Electronic thermometer