Touch Light Dimmer Circuit


Posted on Feb 5, 2014

With IC SLB0586A from Siemens you can build a simple touch light dimmer circuit that will allow you to adjust the lamp intensity. Together with a TIC206D triac, it enables smooth regulation of light intensity from a bulb of 10W 400W. A coil of 100 µH/5A is required to suppress switching noise. The voltage supply is obtained through R2, C2, D1and C3


Touch Light Dimmer Circuit
Click here to download the full size of the above Circuit.

and is about 5. 3V below the network potential. The touch sensor that is used to drive the IC is connected at pin 5 through two 4. 7M © resistors, R5 and R6, in order to ensure user security. In the adjustable touch lamp schematic we can see three selection connection, for selecting one of three modes of the IC. When the B connection is used, the light will always be ON at the last level that we used. With A or C connection the light will be ON at the minimum intensity. With B or C, the purpose of regulation is reversed with each use. When the sensor is touched for a short period of time (50 400 ms), the lamp will be ON or OFF. If the sensor is touched for a longer period of time it will start the regulation process.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    25W 230VAC small size ballast using IR2520D
    Motor control with tachometer
    Positive And Negative Voltage Switching Supply
    bike battery charger schematics
    10 to 1000 MHz Oscillator circuit with RF2506
    0-20V 3A bench PSU
    Vu meter stereo circuit
    Wireless Interface RF Modules Circuit
    20Hz signal generator (phone-ringing) circuit diagram
    Tube amplifier input voltage input



    Top