Traffic Lights Beginner Arduino Project


Posted on Feb 6, 2014

Setup the lights on the breadboard like a traffic light. Red on top, then yellow, and then green. The small red and green are the pedestrian crossing signals. Again red on top and green just below. Put the buttons in so you have at least 2 pin holes space to add the wires and resistors. Place the 1kohm resistor between one side of the button and t


Traffic Lights Beginner Arduino Project
Click here to download the full size of the above Circuit.

he negative run on the breadboard.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    CDV700 Geiger Counter
    Low power audio amplifier
    Latest Intruder Alarm Super Sensitive circuit and explantion
    Latest British Police Car Siren circuit
    Up/Down Timer For A Power Antenna
    RIAA Corrector
    DIY Homemade Ignition Coil Driver



    Top