Ultrasound Pulser


Posted on Feb 6, 2014

The Smart Ballast IC is designed to control a Fluorescent Lamp Ballast including a Discontinuous Conduction Mode Power Factor Correction (PFC), a lamp Inverter Control and a High Voltage Level Shift Half-Bridge Driver. The application requires a minimum of external components. There are integrated low pass Filters and an internal compensation for


Ultrasound Pulser
Click here to download the full size of the above Circuit.

the PFC voltage loop control. Preheating time is adjustable by a single resistor only in the range between 0 and 2000ms. In the same way the preheating frequency and run frequency are set by resistors only. The control concept covers requirements for T5 lamp ballasts such as detection of end-of-life and detection of capacitive mode operation and other protection measures even in multilamp topologies. ICB1FL02G is easy to use and easy to design and therefore a basis for a cost effective solution for fluorescent lamp ballasts. By Infineon Technologies Corporation




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Loudspeaker Protection 2
    Touch Switch Circuit with explnation
    Lighting Control
    DIY ECC802S (12AU7 / ECC82) Vacuum Tube SRPP Preamplifier
    Sense Fluid Levels With Capacitance
    Building power/control interface for RGB LED strips
    Amplifying DC Diode Detector Output
    usb audio interface based dac pcm2902
    Electromagnetic Field Detector
    car reverse beeper
    technical information for leds
    MFOS Ten Step Analog Sequencer
    Third batch start and stop cycle control circuits
    FET high input impedance wideband amplifiers



    Top