audio processor circuit using ic ssm2045


Posted on Feb 6, 2014

This audio processor circuit features the SSM2045 IC which was developed specially for electronic music applications and the 741 opamp IC. The circuit is configured as a low pass filter with a DC voltage control for gain. The input signal is set to a working level of 150mVpp through the resistor R1. The filter has 2 buffered outputs: the 2-pole ou


audio processor circuit using ic ssm2045
Click here to download the full size of the above Circuit.

tput at pin 1 and 4-pole output at pin 8. Internally, the outputs are connected to 2 voltage-controlled-amplifiers (VCA). The R15 and R16 are connected to these outputs to achieve optimum offset and control voltage suppression. P4 is the volume control. The current that flows to the pins 15 and 16 should not go beyond the maximum of 250 µA. The balance of the two VCAs and the entire filter is being controlled be a voltage range of -250 mV to + 250 mV at pin 14. This voltage can be set by P2. The input can be driven with source impedances up to a maximum of 200. With an input level of 0dBm, the VCA weakens by 6 dB. The bias current needed at pin 17 is between 120 µA and 185 µA. The cutoff frequency can be shifted between 20 Hz and 20 kHz with a variable voltage at pin 5. This can be varied through P1. The capacitor values were selected to give the filter its Butterworth characteristics. The output current of the SSM2045 IC is converted to a voltage output by the 741 opamp. Any sybsequent circuit must be DC decoupled from IC2. The noise-voltage ration is about 80 dB.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    2 Digit Counter (PIC12F629)
    RF Dummy load
    Photo alarm
    Wide-bandwidth-peak-detector
    Model Train And Slot-Car Controller
    astable mode of 555 timer
    Baud Rate Generator
    1Hz clock signal generator circuit
    Two electric motors or electrical interlocking control circuit



    Top