broadcast band rf amplifier

Posted on Feb 7, 2014

The circuit has a frequency response ranging from 100Hz to 3 MHz; gain is about 30 dB. Field-effect transistor Q1 is configured in the common-source self-biased mode. Optional resistor R1 allows you to set the input impedance to any desired value; commonly, it will be 50 0. The signal is then direct coupled to Q2, a common-base circuit that isolat

broadcast band rf amplifier
Click here to download the full size of the above Circuit.

es the input and output stages and provides the amplifier`s exceptional stability. Last, Q3 functions as an emitter follower, to provide low output impedance at about 50 O. !fyou need higher output impedance, include resistor R8. It will affect impedance according to this formula: RS `` RoUT -50. Otherwise, connect output capacitor C4 directly to the emitter of Q3.

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    Feedback Bandpass Filter
    Plants Humidity Sensor
    Phone Line Simulator with PIC16F819
    Single chip checks resistance
    Power Mosfet Switch
    Moisture Sensor Project
    atmega 32a programming
    audio visual indicator for telephone circuit diagram
    7809 Pin and
    A variety of low-frequency waveform generator 741 circuit