digital clock using with pic16c54


Posted on Feb 5, 2014

Digital clock project based on the PIC16C54 microcontroller can be designed using the following circuit diagram. This digital clock electronic project based on the PIC16C54 is a simple time-of-day clock incorporating four seven-segment LED displays and three input switches. There is also an additional reset switch that would not normally be incor


digital clock using with pic16c54
Click here to download the full size of the above Circuit.

porated into the final design. The common cathode for each display is turned on with transistors connected to the four I/O lines of PORTA. A low output turns on the PNP transistor for the selected display. The PORTB pins activate the LED segments. Pressing SW1 will cause seconds to be displayed. The time is set by pressing SW2 to advance minutes, and SW3 to advance hours. The displays used were common cathode and turned on with transistors to avoid trying to sink too much current into the PIC16C5X. 100 W resistors were used in series with the segments to obtain the desired brightness. Different values may be required if different displays are used. This digital clock project based on the PIC16C54 microcontroller ( circuit and software ) was designed by Dan Matthews Microchip Technology Inc. Download Source Code




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    VLF Radio Receiver circuit
    Multi-color LED driver
    Basic Tone Control
    how to design h bridge circuit for
    Audio Oscillator
    Liquid-Crystal Display (LCD) Tester
    REMOTE CONTROL TRANSMIITER
    Light-emitting diode rectifier circuit
    Interpretation of visual fatigue eliminator Circuit Design



    Top