digital to analog


Posted on Feb 7, 2014

This can be used to convert a byte sent from a microcontroller to a analog value like say 1. 51 V. At full scale, when all 8 bits are high calibrate to give 2. 55 V then ever bit increment is 0. 01V, 10mV steps. If the eight bits inputs are from a counter you then will see a staircase waveform at output, each step being 10mV higher or lower depending


digital to analog
Click here to download the full size of the above Circuit.

on whether the counter is counting up or down. The accuracy of the analog output depends on the resistor ladder. The OP07 has an offset error of about 70uV only. The 74HCT373 power is derived from LM336 a stable reference so that the D-A is accurate. The 8 bit data can be latched with the 74HCT373 to get a stable analog value for control systems.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Microcontrolled Lab Power Supply
Three phase square-wave output generator
The Link Telephone Intercom Every Home Should Have One!
Arduino Light Sensors
Three Axis Mag
1RE30 DATA TRANSMISSION USING LASER
GigaHertz Signal Detector Circuit
Arduino controlling a DC Motor
Headlamp dimmer controlled foglamps FORD RAPTOR
Digital Radar Speedometer
FREQUENCY COUNTER
5-channel low-power programmable sensor signal processor with AD7714 circuit
Isolated two-wire current loop circuit diagram XTR101 ISO100



Top