mini mosfet audio amplifier


Posted on Feb 6, 2014

This project was a sort of challenge: designing an audio amplifier capable of delivering a decent output power with a minimum parts count, without sacrificing quality. The Power Amplifier section employs only three transistors and a handful of resistors and capacitors in a shunt feedback configuration but can deliver more than 18W into 8 Ohm with


mini mosfet audio amplifier
Click here to download the full size of the above Circuit.

<0. 08% THD @ 1KHz at the onset of clipping (0. 04% @ 1W - 1KHz and 0. 02% @ 1W - 10KHz) and up to 30W into a 4 Ohm load. To obtain such a performance and to ensure overall stability of this very simple circuitry, a suitable regulated dc power supply is mandatory. This is not a snag because it also helps in keeping noise and hum of the preamp to very low levels and guarantees a predictable output power into different load impedances. Finally, as the amplifier requires only a single rail supply, a very good dc voltage regulator capable of supplying more than 2 Amps @ 40V can be implemented with a few parts also.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

AC Motor Speed Control circuit
Precision battery voltage monitor
Power pack for battery-powered devices
Automobile-air-conditioner
Transistor Sensor Temperature Measurer
Arduino SFR Ranger Reader
FM Transmitter circuit using 2N2222
Updated 60-100W Hi-Fi Power Amplifier
Frequency/Tone Decoder Circuit Using TC9400 FVC
BQ24400 Switch-mode NiCd/NiMH Battery Charger With Peak Voltage Detection Termination
Energy-Saving Switch Schematic
Liquid detector circuit diagram electronic project
DTMF Decoder 2
Infrared Remote Receiver Has Four Outputs
A Dozen Small Battery-Powered Alarm Projects



Top