Lamp-flasher


Posted on May 2, 2012

The circuit is built around two power FETs, which are configured as a simple astable multivibrator to alternately switch the two lamps on and off. The rc values given sets the flash rate to about 1/3 Hz. By varying either the resistor or capacitor values, almost any flash rate can be obtained. Increase either Cl and C2, or Rl and R2, and the flash rate slows.


Lamp-flasher
Click here to download the full size of the above Circuit.

Decrease them and the rate increases.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

High Impedance Voltmeter LM358
Active Antenna
Advanced Light Dimmer
Electronic-tremolo
0-50V 2A Bench power supply circuit and explanation
Light dimmer circuit using DIAC and TRIAC
overcurrent detection circuit
Speaker Microphone circuit diagrams
10 300V variable power supply circuit design diagram electronic project
Sound Level Indicator
Attaching a GPS module to the EB675001DIP
5V to 2.5V voltage regulator circuit



Top