Blanking Circuit for Oscilloscope


Posted on May 15, 2012

This circuit blanks the CRT starting just before retrace begins. Since the CRT sits at a -1200 volt potential, the blanking circuit must also be based at -1200 volts. Note the capacitors, C40, C41, and C43 which allow the gates that drive the intensity grid of the CRT to be isolated from the other electronics within the oscilloscope.


Blanking Circuit for Oscilloscope
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

LM317 Regulator Circuit
6.5Mhz Vfo Circuit
Simple AM Radio Receiver circuit and explanation
High power siren circuit using CD40106
Design and simulation study of anti exciting type switching power supply of single-end
Dome Drive Schematic
audible logic probe
connection tester schematics
Ultrasonic parking sonar circuit design project
555 Timer as an A/D converter
800 W soft start light dimmer
USB-Powered PIC Programmer
Automatic recording telephone interface circuit
Car battery charging circuit diagram
Fast charging circuit TEA1102



Top