MSC1210 Reset Circuit


Posted on Feb 11, 2013

According to the MSC1210 datasheet, you will perform an external reset by taking RST pin high for two tOSC periods as this stops device operation, crystal oscillation, causes all digitall pins to be pulled high from that point and then followed by taking the RST pin low that initiates the reset procedure.



MSC1210 Reset Circuit - image 1
Click here to download the full size of the above Image.

Herein a typical reset circuit of the MSC1210-a precision Analog-to-Digital Converter (ADC) with 8051 Microcontroller and Flash Memory schematic that can be done from the following sources: power-on reset, external reset, software reset, watchdog timer reset, and brownout reset. The figure (click to enlarge) shows a recommended external reset circuit for the MSC1210 with the serial 10kOhm resistor recomendation for any configuration of this reset type.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Photocell memory switch for AC power control
simple automatic street light system
dc to dc converter
Telephone in use indicator
Power Quality Improvement Using Switch Mode Regulator
Audio Speaker Crossover Circuit
Simple Short-Circuit Detection
FOLDBACK CURRENT LIMITER
Circuit Audio Stereo power amplifier LM4755 11W with Mute
Light Bus speed detecting circuit diagrams
Digital DC Millivoltmeter



Top