Simple Utility Mixer


Posted on Jun 25, 2012

Here`s an interesting mixer circuit. With it you can effectively combine signals from audio to high-fre-quency RF. Als


Simple Utility Mixer
Click here to download the full size of the above Circuit.

o, as a special bonus, this circuit will provide some gain at a low noise figure. The inputs can be of almost any level or impedance, and the output (low-Z) will drive most tuned circuits or transistors. Basically, the device consists of two similar FET amplifier stages with a common load resistor (R2). Each FET develops a signal across this resistor, a form of cancellation occurs, and a difference signal results. If you want less gain, try reducing R2 to 2 200-. This modification will not affect the mixing ability.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

High-power battery-operated flasher
Peak detect and hold
Solar Panel Based Charger And Small LED Lamp
Interfacing LCD with 8051
Rc Cars Cmos
1RE30 DATA TRANSMISSION USING LASER
jammer circuit
active balanced ground
lf352 Programming the AVR microcontroller with GCC libc 1.0.4
water alarm schematic
4 ~ 20mA transmitter circuit diagram TMP35 temperature
Constituted by the PGA103 programmable gain instrumentation amplifier circuit diagram
ISO100 sensing signal isolation amplifier



Top