Car Alarm and Immobilizer


Posted on Mar 24, 2013

The alarm is `set` by opening Sw1. It can be any small 1-amp single-pole change-over switch - but for added security you could use a key-switch. Once Sw1 is opened you have about 10 to 15 seconds to get out of the vehicle and close the door behind you. When you return and open the door the buzzer will sound. You have 10 to 15 seconds to move Sw1 to the `off` position. If you fail to do so, the siren will sound.


Car Alarm and Immobilizer
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Stereo-indicator
Analog Equaliser
Schematics VHF FM Receiver TDA7000 88-108 MHz
designing a phantom antenna power supply system
Delay Loops
BiQuad Filter Circuit Diagram using LM3403 Quad Op Amp
The 2N5109 Amplifiers
Programmable Home Security Alarm System
THREE FREQUENCY AUDIO OSCILLATOR
Norton high voltage inverting amplifier
LED display control circuit diagram of a counter



Top