10-Band Graphic Equalizer


Posted on Feb 6, 2014

This circuit allows you to equlize the audio signals in 10 band. It uses low amount op-amps (TL074 - JFET op-amp) to anatomy a able blaster circuit. The affection of the architecture is a classical band-pass alive filter. The VCC is in ambit of 12 ~ 15 VDC and The VDD is in ambit of -12 ~ -15 VDC respectively. As shown in the diagram, there are 10


10-Band Graphic Equalizer
Click here to download the full size of the above Circuit.

same units that only differ in capacitance values of capacitors which determine the frequency band of each filter. The potentiometers adjust the predetermined regions of frequency in each unit. If it is intended for stereo use then it will be supposed it is made in two pieces with as much as possible suited the materials, between the channels, so that do not exist differences in the regulation of each band frequencies. Switch S1 isolates the circuit EQ, when him we did not need and it ensures level [ flat ] response in the exit of circuit. The circuit should be connected between preamplifier and in a final power amplifier.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Field-programmable Operational Transresistance Amplifier using Floating-gate MOSFETs
    Safety Measures in Constructing EMG Amplifiers
    programming pen usb interface
    LED Bike Light Circuit Project
    USB Power Injector For External Hard Drives
    infrared extending IR range
    One simple second pulse source circuit
    Voice-activated toy car circuit



    Top