24v 7ah lead acid battery charger

Posted on Feb 5, 2014

This lead acid battery charger circuit is designed in response to a request from Mr. Devdas. C. His requirement was a circuit to charge two 12V/7AH lead acid batteries in series. Anyway he did not mentioned the no of cells per each 12V battery. The no of cells/battery is also an important parameter and here I designed the circuit assuming each 12V b

24v 7ah lead acid battery charger
Click here to download the full size of the above Circuit.

attery containing 6 cells. When two batteries are connected in series, the voltage will add up and the current capacity remains same. So two 12V/7AH batteries connected in series can be considered as a 24V/7AH battery. The circuit given here is a current limited lead acid battery charger built around the famous variable voltage regulator IC LM 317. The charging current depends on the value of resistor R2 and here it is set to be 700mA. Resistor R3 and POT R4 determines the charging voltage. Transformer T1 steps down the mains voltage and bridge D1 does the job of rectification. C1 is the filter capacitor. Diode D1 prevents the reverse flow of current from the battery when charger is switched OFF or when mains power is not available. To setup the charging voltage, power ON the charger and hook up a voltmeter across the output terminals and adjust R4 to make the voltmeter read 28V. Now the charger is ready and you can connect the batteries.

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    12 volt power supply (7812)
    voltage inverter
    Simple Amplified Field Strength Meter Circuit
    Sine Wave Generator Circuit
    One Direction Motion Sensor
    communication Multiplex data and LED pin
    Digital Alarm Speedometer Circuit
    reference design modern prtd sensors and delta sigma adcs
    Fun with Arduino
    More on the plant sensor
    Simple RS232 Serial Interface Circuit