Arduino Serial Call Response


Posted on Feb 5, 2014

This sketch sends an ASCII A (byte of value 65) on startup and repeats that until it gets a serial response from the computer. Then it sends three sensor values as single bytes, and waits for another response from the computer. You can use the Arduino serial monitor to view the sent data, or it can be read by Processing (see code below), Flash, PD


Arduino Serial Call Response
Click here to download the full size of the above Circuit.

, Max/MSP (see example below), etc. Connect analog sensors to analog input pin 0 and 1 with 10K ohm resistors used as voltage dividers. Connect a pushbutton or switch to digital I/O pin 2 with a 10Kohm resistor as a reference to ground.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    3 LED - 1 Cell battery tester
    Capacitor-discharge-high-voltage-generator
    Carrier-Current Baby-Alert Transmitter Circuit
    DC Lessons In Electric Circuits
    how to make simple active low pass
    Light Activated Relay with 555 Circuit
    Four crystal diode switching circuit diagram of the IF filter
    Dynamic noise reduction with DC volume control



    Top