Colloidal Silver Water Generator


Posted on Feb 7, 2014

By selecting `ON` mode the the SilverPro© start the process of generating the colloidal using the your presetSetup parameters. The unit allways recall the last used presets. During it`s operation the display scrolls between the total minutes elapsed, the present electrical current through the emulsion measured in milliamperes (0. 1 milliampere resolu


Colloidal Silver Water Generator
Click here to download the full size of the above Circuit.

tion) and voltage measured across the emulsion ( 1 Volt resolution) which represent it`s conductivity. When finally it reaches a predefined threshold set by the "U" parameter (defined in the "Setup"process ) it displays "Ready" and 5 voice alerts to indicate the end of the process.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Overvoltage protection for RS232
Overtone crystal oscillator
Detector And Controller
Digital Voice Record and Playback Project by ISD2560P
Regulated Dual Power Supply Circuit Using Regulator IC
water level sensor circuit
Filaments Detection Circuit
switching ac loads triac
Variable Power Supply 0-24V
The oscillator with electronic tuning of frequency
OCL AC negative feedback amplifier analysis
Insulation resistance meter circuit
Capacitive proximity sensor detection circuit
DAC0832 interface circuit with the 8-bit CPU



Top