Night Light circuit


Posted on Feb 6, 2014

The Saver V5. 0 runs simple clock emulation program, turns a night light on and off with preset time, say 19:00 to 22:00 everyday. The design features low cost, easy installation, no battery backup and no EMI. The AT89C2051 uses external oscillator generated by schmitt trigger gate CD4093, ~680kHz. Reference frequency was derived from 50Hz main lin


Night Light circuit
Click here to download the full size of the above Circuit.

e. Time setting only allows at 18:00 by pressing time set button once. If main line has failed, functioning LED will blink at high rate. Since there is no battery backup, thus repressing the button is then needed. The output is capable of driving say, a 25W incandescent lamp. 1)Transformerless direct supply: R1 and C1 forms a simple current limitting AC source. D1 and D2 converts AC to DC with C2 performing a reservoir. D3 limits voltage across the circuit to ~5V. 3)89C2051 circuits: C4, 33uF and R4, 10k forms a reset circuit that need time for riasing logic at least two machines cycle. S1 is a momentary button for setting time to 18:00 by pulling P3. 0 to logic low. The functioning LED is connected to P3. 7. Q2 is a small triac MAC97A6, and is drived by Q1, PNP transistor sinking through P1. 7. 4)Reference frequency: R3 and C3 integrates a 50Hz main frequency and unwanted transients producing triangle-like waveform which is fed to U2 schmitt gate. The output pin4 is clean 50Hz square wave tied to int0. Saver5. hex is HEX file suitable for Easy-Downloader V1. 1 for writing the code to the chip. This file sets time to 18:00 when press S1 once. Time on and off is set to 19:00 to 22:00 everyday. And finally the reference main frequency is 50Hz! The original source program SAVER5. C was written in `C` language. User may change set time when press S1 and change time on/off. It is a good idea to include peak shaving period, say...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Sound trigger for flash unit
    figureyaga - lead acid battery charger circuit schematic
    Heat Sensitive Switch
    buzzer only beep once
    Low voltage DC power charger circuit
    Basic circuit diagram connection of signal and power INA166
    DDR memory power supply circuit



    Top