Simple audio mixer circuit with fet 2N3819

Posted on Feb 6, 2014

This circuit is a simple mixer circuit. It can mix two signal channels and one channel is output. Using a codec circuit, Convert stereo audio to mono audio time. -In circuit a FET number 2N3819 is main, it is better than a common transistors that a high impedane input and high gain too. so cause low noise and. It can increase the number of channels

Simple audio mixer circuit with fet 2N3819
Click here to download the full size of the above Circuit.

too, By adding a VR1, R1 and C1 to the amount needed. Then connected to Buffett a new one. Most importantly is eating circuit current is very low. Can use with 9-volt batteries immediately. When entering voice signal, one of input 1 and input 2. Audio is via C1 and C2 of each channel, served coupling signals to VR1 and VR2. To adjust the audio to the Fet Q1. Which it serves, including audio. Then expand signal the output pin S through C3 For coupling signal again, before leaving to the output. Some time you want high gain than FET, I think an OP-AMP IC is good way for you. The LF353 has JFET within it so very well same common FET but it has many components inside it, makes high gain and better than 2N3819 but in normal using we may need it because too cost in some places. This is a very simple 4-channel audio mixer. We used a number IC of LF353 is the main equipment, the function of each channel combined with upper signal level. They is low noise for J-fet op-amp IC (NO. View to LF353)

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    Precise One Shot Circuit
    oscillator HEF4060B counter doesnt count
    12 Volt Toilet Tank Refiller
    Speed controller circuit change please help
    Assembly of the F&DARC Square Wave Generator/Bridge
    Moving Sensor / Detector Schematic Diagram using IC NE555 and Phototransistor L14F
    Darkroom time exposure of the second circuit
    Bidirectional thyristor AC contactor interface circuit