economy radar detector


Posted on Feb 6, 2014

This circuit uses a 1458 dual op-amp to form a radar detector. C1 is the detector of the radar signal. The first op-amp forms a current-to-voltage converter and the second op-amp buffers the output to drive the piezo transducer. R5 sets the switching threshold of the second op-amp; normally it is adjusted so that the circuit barely triggers on bac


economy radar detector
Click here to download the full size of the above Circuit.

kground noise, then it`s backed off a bit. The response of the circuit may be tuned by adjusting the length of the leads on C1. For typical road-radar systems, the input capacitor`s leads should be about 0. 5 to 0. 6 inches long.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Linear Resistance Meter
    avr How to redesign a circuit to use a current sinking IC rather than a current sourcing IC
    Protecting Microcontroller Input Pins from Soft Power Switch
    Arduino Runing On && Charging NiMH batteries
    Questions about colpitts oscillator design
    whats wrong my h bridge drivers
    A Regenerative Receiver with AGC for 80 Meters or 3-10 MHz Shortwave
    Voice Link Over Spread Spectrum Radio
    Hybrid power amplifier 01



    Top