Stairs Corridor light-controlled circuit


Posted on Mar 28, 2007

Circuit shown in Figure 2-50. This circuit uses field effect tube should, through the ingenious electronic components constitute a unique self-lighting controller. The informal


Stairs Corridor light-controlled circuit
Click here to download the full size of the above Circuit.

working lamp illumination is not put out off, but the light is dim. In some cases this is needed. At the same time, this can greatly extend the life of lamps, because before fully lighting the lamp filament has a large cooler state filament resistance, thus avoiding that a large electric lamp connected to the grid when the impact of flow. Delay time is determined by Ci, Ri, as shown by numerical Figure 2-50 about 6min. To disconnect from the controller and enhanced lighting, for example, when cleaning stairs, hit the switch SA may be closed position, then the lamp will add a full-grid voltage.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

AM LOOP ANTENNAS
Simple CB receiver with SO42P
IR remote control for PC
Voice link over spread spectrum radio
opto isolator Ring detector circuit transistors not fully activating
stereo led power vu meter
Wire loop alarm
LSB Conversion of RT321 and RT320 HF Sets
communication with AVR microcontroller
KL-25 type automatic thyristor excitation device circuit



Top