Roulette with LED Display

Posted on Mar 14, 2013

This circuit is a small digital ?roulette''. It is constituted by oscillator IC1, the counter IC2, the transistors Q1-7 that drive the display common cathode DSP1. The supply basically becomes from a battery 9V, but can become also from one power supply. The regulation of frequency should become in the 10HZ or little bigger, with to pontesometer TR1 combination with the C1, which we can change the capacity, changing thus and the frequency of oscillator. Bigger frequency means faster speed in ??rolling?? the indicate in the display. M? the TR2 we alter the time where will last the measurement, afterwards the release of S1. With the S2 we make RESET in the display. With the S1, we make departure in the circuit and simultaneously RESET, when start after a circle.

Roulette with LED Display
Click here to download the full size of the above Circuit.

When we release the S1, the meter stops in number, then it should we press again the S1, so that begins new circle of game or we make nihilism via the S2. If comes zero then the player that makes '' mother '', it can take all the '' profits, from all the other players. In the game they can take part, from two up to nine players. The TR1-2 can be in form trimmer or potentiometer, proportionally what us accomodates. R1= 10Kohms Q1-8= BC550 TR1= 470Kohms trim. or pot. lin R2-9= 1Kohms DSP1= Display 7 segment common cathode TR2= 100Kohms trim. or pot. lin C1= 0.47 until 2.2uF 16V IC1= 4011 S1= 1?2 Switch C2= 100uF 16V IC2= 4026 S2-3= Push Button normal open C3= 47uF 16V D1-2= 1N4148 BATT= 9V Battery ?r ext. supply

Leave Comment

characters left:

New Circuits



Popular Circuits

Basic LM386 audio amplifier schematic
3V Power Supply For Portable Radios
photo sensor control relay
Evaluation Board For Single Supply 12-bit 500 Ksps Adc
Misc RF Topics
DIY Intercom Design Thread 4
Lightning Detectors