Cost-effective nickel-cadmium battery charger LM393


Posted on Dec 11, 2010

Cost-effective nickel-cadmium battery charger LM393 constructed as shown, it has the following characteristics: (1) constant current charging interspersed with large current di


Cost-effective nickel-cadmium battery charger LM393
Click here to download the full size of the above Circuit.

scharge, constant current charging current of about 300mA, the discharge current as the battery voltage increases and increased nearly full battery discharge current up to 400mA. Charging 1.5 seconds, 0.5 seconds discharge, intervals. After the high-current charging is completed, about 5mA trickle charge. (2) the detection of the battery voltage when the discharging is carried out, because the charging voltage is always higher than the discharge voltage, when charging is detected as the actual cell state error, but also reflects the battery is detected during discharge capacity. (3) rechargeable batteries can be 1-4, for 500mAh nickel-cadmium batteries, the charging time is about two hours, to meet the general needs.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

50 MHz range frequency counter using ATtiny45 microcontroller
Guitar Schematics
Cosine wave Oscillator
4KHz-170MHz Wide Band RF Signal Generator I
Linear SuperCap Charger with Current-Limited Ideal Diode and V/I Monitor
Practical Data Acquisition using a Windows based Power Meter
Dual flashing string circuit 2



Top