40 Pin PIC Development Board
This prototype board serves as a versatile platform for developing and testing applications based on 40-pin PIC microcontrollers. The inclusion of a power supply circuit ensures stable operation, allowing the microcontroller to function effectively across various voltage levels, typically from 5V to 15V. This flexibility is crucial for prototyping, as it accommodates different configurations and requirements.
The 20MHz crystal oscillator circuit is integrated into the design to provide a precise clock signal, essential for the microcontroller's timing operations. The frequency of 20MHz is suitable for a wide range of applications, providing a balance between performance and power consumption.
An RS232 port is included for serial communication, allowing the microcontroller to interface with other devices, such as computers or other microcontrollers. This port facilitates data exchange and programming, making it easier to debug and monitor the system's performance during development.
The ICSP (In-Circuit Serial Programming) and ICD (In-Circuit Debugging) programming ports are critical features that enable developers to program and debug the microcontroller without removing it from the circuit. This capability significantly enhances the development process, allowing for real-time updates and modifications to the firmware.
Overall, this prototype board is a comprehensive solution for engineers and developers looking to leverage the capabilities of 40-pin PIC microcontrollers in various applications, providing ample resources for analog-to-digital conversions and programming space for complex code implementations.If you need lots of Analog to Digital channels, or plenty of program space (up to 32K!), this one is for you! Prototype board for 40 pin PIC microcontrollers with power supply circuit, 20MHz crystal oscillator circuit, RS232 port, ICSP/ICD programming port.
🔗 External reference
Related Circuits
The microcontroller used is an ATMega8 operating at a frequency of 16MHz. This microcontroller can output arbitrary waveforms from its flash or SRAM storage at a rate of 2MS/s or even higher. The 8-bit data is sent from port...
Is it feasible to eliminate the Electronic Speed Controllers (ESCs) from a multicopter configuration and substitute them with a single circuit board to control all the motors? The current setup consists of eight motors, each requiring an individual ESC,...
This is a general purpose remote control project with using programmable PIC microcontrollers. Schematics are shown for using infrared (RF) or radio (RF) media. If you are not familiar with microcontroller programming, you can use fixed encoder and decoder...
The project involves displaying the current room temperature using an LM35 temperature sensor. This schematic differs from a previous schematic that utilized a multiplexed seven-segment display. In the earlier schematic, the display select I/O pins were RA0, RA1, RA2,...
I tried to design a timer that would do everything it needed to do but with the smallest number of pieces and simplest mode of operation. It only needs the PIC, a four digit LED display, one other IC,...
External circuit converts bass beat of music into pulses. The motor is controlled by them. If there's bass beat recognized then the motor rotates one direction (in full stepping) for a predefined time then stops. If the second beat...