2x 2,500W RMS stereo amplifier


Posted on Sep 19, 2012

This circuit is of an 2x 2,500W RMS stereo amplifier, super-light and without switching-mode power supply. The circuit just shows a channel, and the power supply that it assists to the two channels. The audio circuit should be duplicated, but the power supply assists to the two channels without problems. A special care should be destined to the insulating transformer of the audio line, that should be of audio-high-quality, of the type used in microphone pre amps input line. The whole group (2 channels) of 5,000W RMS it should not weigh more than 32 lbs, already inside of an appropriate metallic box.


2x 2,500W RMS stereo amplifier
Click here to download the full size of the above Circuit.

This circuit is exclusively for amateur use. It contains not-isolated parts of the electric AC net and it can be very dangerous. The connections for the speakers are not isolated of the domestic AC net and it requests extra care. This procedure seeks to substitute a conventional power supply with great weight and cost reduction, without necessarily to use a switching-mode power supply. This procedure cannot be allowed in some countries for commercial-use. The author doesn't have any responsibility for the form as that circuit it will be applied.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Portable-rf-burst-generator
    Wien bridge oscillator
    Sensitive Overload Sensor
    LED TesterCircuit
    Symmetrical power supply circuit electronic project
    2500W Phase Control
    A New Solar / Wind Charge Controller Based on the 555 Chip
    LED Pumpkin Candles for Colorful Halloween Jack-O-Lanterns
    Extended common mode range of the instrumentation amplifier (INA101) circuit
    555 ultra-low frequency signal generator circuit diagram of a millivolt



    Top