Adjustable high-frequency notch filter


Posted on Jun 1, 2012

Although you can obtain universal, resistor-programmable switched -capacitor filters that are configurable as notch filters, most cannot operate at bandwidths higher than 100 kHz. Further, the typically 16- to 20-pin packages do not include a continuous -time, antialiasing filter to prevent spurious signals from appearing at the output. By using an eight-pin, dual operational amplifier and an eight-pin, switched-capacitor bandpass filter, you can construct a notch filter (Figure 1). IC2, a TLC082 is a dual BiCMOS op amp, replacing the older JFET-input stage with lower noise CMOS but retaining the bipolar output for high drive capability.


Adjustable high-frequency notch filter
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

12dB / Octave Linkwitz Riley Crossover
Motor-tachometer speed control
Sun-tracker
UltraSonic Radars
20dB VHF Amplifiers
Capacitive SensorCircuit
Build a 5A H-bridge Motor driver! Old version
direction detector decoder
Operational amplifier
A simple TTL modulated diode laser
Beginning Embedded Electronics - 1



Top