OTL tube amp amplifier production


Posted on Mar 28, 2007

6N5P the output impedance of 400 ohms low resistance tube used as a parallel push-pull, the output impedance of a single tube half, and then two-three-plate and pipe used in pa


OTL tube amp amplifier production
Click here to download the full size of the above Circuit.

rallel, the impedance will be further reduced, it can be removed from the output transformer used double supply and reasonable bias position adjustment, can be removed from the output capacitor, the whole circuit is shown in Figure 1-33. The figure shows the operating voltage o RPl between levels. RP2 set maximum resistance for adjusting the final stage and screen flow midpoint output. Multimeter set 1V block were measured and down tube 5 (! Voltage across the resistor, adjust RP1, RP2 so drop across the resistor 0.2V.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Touch Switch
300w power inverter circuit diagram
H Bridge tutorial
Feeding CB and Ham radio audio into the aux circuit
Square Wave Oscillator
A thirty light water digital control circuit



Top