Attiny2313 based LAN cable tester


Posted on Feb 6, 2014

Vasilis Stergiopoulos has built a RJ45 LAN cable tester. The circuit was originally designed to use a 555 and 4017 IC, but Vasilis has published the schematic and source code in assembly for using the Attiny2313 instead. The Attiny2313 produces successive outputs at port D, where the LAN-cable is connected. If a straight cable is connected between


Attiny2313 based LAN cable tester
Click here to download the full size of the above Circuit.

connectors A and B, then the LEDs will glow in successive order. If a cross cable is connected, then the glow order will be as noted on the board, i. e. 1, 2, 7, 4, 5, 8, 3, 6. If any other glow order occurs, it means that the cable is not wired correctly. If one or more LEDs don`t glow, then we have a corresponding open circuit. A remote unit with only the B connector (B2) can be used if both cable ends are not accessible in the same location.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Laser Data Link schematic
Arduino multi-mode lamp with soft touch switch
CDI Capacitor Discharge Ignition Circuit
simple led automatic daynight lamp
AC Phase control
shootable simon game
parallel PIC
Synchronous Camera Flash Trigger Using IGBT
Loudspeaker Protector Monitors Current



Top