LM3552 white LED driver circuit design


Posted on Feb 7, 2014

For this led driver electronic project you will need a DC power supply circuit that provide an output voltage between 2. 7V and 5. 5 volts ( supply voltage must be applied between Vin and GND. The T/F jumper connects the T  post to the middle post of the T/F header strip. This connects GND to the T/F pin of the LM3552, placing the part into the 2


LM3552 white LED driver circuit design
Click here to download the full size of the above Circuit.

00mA torch mode when the part is enabled. When these connections are all made correctly, the Flash LED will be OFF. Setting the EN jumper to the ON position will enable the part and turn on the flash LED. In torch mode, the LED current will be set to approximately 200mA. Placing the T/F jumper across the `+` pin and the T/F pin enables flash mode. The total current delivered to the LED is approximately 700mA. If this jumper is left in flash mode, the internal time-out circuit will disable the switcher after approximately 1 second. The EN pin has an internal pull-down resistor placing the part in shutdown by default and the T/F pin does not have a pull-up or pull-down resistor. If left unconnected, it is unknown as to whether the LM3552 is in torch or flash mode.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Digital Volume Control
    KC2ZPLs Web Design and Electronic Home
    Another kind of relay driver board used to utilize your old PC
    Light circuit diagram: Electromagnetic Sensor Circuit Using 741 IC
    vu meter em84
    make tv transmitter
    LB1948M motor control driver electronic circuit design
    UNDERVOLTAGE DISCONNECT SWITCH
    555 tri-state acousto-optical logic circuit



    Top