Need Help: Wiring LEDs with 2 source voltages


Posted on Feb 5, 2014

A series of LEDs I would like to have display at 2 brightness levels and am confused how to properly wire this. This is for additional running lights/brake lights on my bike. When using the series LED calculator I believe for the Source voltage 1 I should set the forward voltage to 1. 1V and 75ma (half of typical voltage and half of forwardcurrent) and then set the Source Voltage 2 to 1. 1V and 75ma


Need Help: Wiring LEDs with 2 source voltages
Click here to download the full size of the above Circuit.

(the other half of voltage and forward current). That in my eyes would result 2. 2V and 150ma.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Guitar OmniDrive effect
    Low-frequency oscillator 10-150khz
    Level sensor for cryogenic fluids
    Two-terminal-touch-switch
    Picture-fixer-inverter
    Remote-Control Transmitter Circuit
    FM wireless transmitters
    100 transistor circuits
    rf mod
    mass air flow maf sensor circuit
    Ultrasonic remote control switch lighting circuit
    NE5532 manufactured by headphone amplifier circuit



    Top