Water Level Alert


Posted on Feb 5, 2014

This circuit will emit an intermittent beep (or will flash a LED) when the water contained into a recipient has reached the desired level. It should be mounted on top of the recipient (e. g. a plastic tank) by means of two crocodile clips, acting also as probes. If a deeper sensing level is needed, the clips can be extended by means of two pieces o


Water Level Alert
Click here to download the full size of the above Circuit.

f stiff wire (see pictures). IC1, a 555 CMos timer chip, is wired as an astable multivibrator whose operating frequency is set by C1, R1 and R2, plus the resistance presented by water across the probes. If the resistance across the probes is zero (i. e. probes shorted), the output frequency will be about 3Hz and the sounder will beep (or the LED will flash) about three times per second. As water usually presents a certain amount of resistance, the actual oscillation frequency will be lower: less than one beep/flash per second. As probes will be increasingly immersed in water, the resistance across them will decrease and the oscillation frequency of IC1 will increase. This means that a rough aural or visual indication of the level reached by water will be available. If a LED is chosen as the alert, C2, D1 and D2 must be added to the circuit in order to double the output voltage, thus allowing proper LED operation (see the rightmost part of the schematics). Interesting features of this circuit are 1. 5V supply and ultra-low current consumption: 40 µA in stand-by and 0. 5mA in operation. This allows a single AAA alkaline cell to last several years and the saving of the power on/off switch. If a LED alert is needed instead of the beeper, R2 value must be changed to 10K, the Piezo sounder can be omitted and D1, D2 and C2 must be added, as shown in the rightmost part of the schematics.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    0-50V 2A power supply with LM10C
    Mobile voltage regulator
    High quality pc audio amplifier
    Improvements in the Design and Performance of PWLL
    9V FM Radio Transmitter
    Guitar pre-amplifier using uA 741
    Bipolar Regenerative receiver
    Inverting Micropower DC/DC Converters with Schottky
    Subcutaneous Transmitter
    555 IC using a delay circuit of the four b
    Optically isolated RS485 circuit diagram of a typical
    One way to prevent reverse polarity of the DC power supply circuit
    Neon high-voltage power supply circuit diagram



    Top