display and serial interfacing of


Posted on Feb 5, 2014

This hardware is used to display the number of cars in the parking lot. Basically, this board has six-segment display but using only one display can do our work. It used segment driver IC SN7447AN and 3*8 decoder to select the corresponding display. This unit is to display the number of cars in parking lot on the computer. The computer may be plac


display and serial interfacing of
Click here to download the full size of the above Circuit.

ed in any control room. Serial cable is used in null modem mode. We use the DB9 connector for serial interfacing. In null modem mode pin 7, 8 and pin 6, 4 are shorted with each other. While pin 3 is used for transmit data and pin 2 for reception. Computer and the micro-controller are connected to each other by serial port through ICL232 (IC 1), the only purpose of which is to convert the voltage levels to the compatible values. ICL232 needs to be used because the TTL and RS-232 voltage levels are different. In TTL, +5V and 0V are considered as high and low respectively, whereas for RS-232 these are 3V and +3V.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    digital clock circuit
    40W/8ohms Audio Amplifier
    10.58 to 10.74 mhz vfo oscillator circuit
    Simple Switched Servo Driver
    555 audio oscillator
    20W + 20W stereo amplifier circuit diagram



    Top