phase shift oscillator circuit


Posted on Feb 5, 2014

This is a design circuit of a simple inexpensive amplitude stabilized phase shift sine wave oscillator which requires one IC package, three transistors and runs off a single supply. This circuit is combination with the RC network comprises a phase shift configuration and oscillates at about 12 kHz. The remaining circuitry provides amplitude stabil


phase shift oscillator circuit
Click here to download the full size of the above Circuit.

ity. Here`s the schematic figure of the circuit. The high impedance output at Q2s collector is fed to the input of the LM386 via the 10 F-1M series network. This circuit is using op amp LM386 causes it has fixed gain of 20. The 1M resistor in combination with the internal 50 k © unit in the LM386 divides Q2s output by 20. The positive peaks at the amplifier output are rectified and stored in the 5 F capacitor. This potential is fed to the base of Q3. Q3s collector current will vary with the difference between its base and emitter voltages. Since the emitter voltage is fixed by the LM313 1. 2V reference, Q3 performs a comparison function and its collector current modulates Q1s base voltage. Q1, an emitter follower, provides servo controlled drive to the Q2 oscillator.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Audio Mixer with preamplifier
    How the capacitor works (in a debouncing circuit)
    Atmel 89C2051 In-Circuit Programmer
    Quality Stereo Wireless Microphone or Audio Link
    Capacitive Touch Sensor
    20W bus circuit radio and megaphone
    Coship CDVB3188V receiver switching power supply circuit



    Top