pippin qrp transmitter


Posted on Feb 6, 2014

Basically, it is a conventional Colpitt type crystal oscillator but with the output taken from a low value collector load resistor and direct coupling is made into the base of the PNP device used as an amplifier. The result is a circuit even more simple than the OXO and with considerable advantages. The small amount of forward bias developed for t


pippin qrp transmitter
Click here to download the full size of the above Circuit.

he PA stage makes it very much easier to drive but is less than the voltage required to actually bias the stage "ON". Keying is in the emitter circuit of the oscillator stage and when the key is up and no current is being drawn there is no forward bias at all on the PA stages. The isolation of the PA from the oscillator by taking the drive from the low value oscillator collector load, is most impressive and there is virtually no pulling of the oscillator even if the PA load is briefly shorted to ground. Input to the PA stage runs at 120 to 150mA. at 12 to 14 volts and output on 7Mhz runs at better than 1 watt measured into a 50 ohm load. The PA transistor has a "Stove Pipe" heat sink attached and has been left running continously for more than 1 hour without any complaint from the PA stage.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    18 LED sequencer timer
    vhf dip meter
    microcontroller Digital bargraph display driver circuit
    crystal oscillator circuits
    Fridge Door Alarm Schematic 2nd Version
    Focusser
    RING COUNTER WITH VISUAL READOUT
    Bathroom automatic hand dryer circuit
    Conducting pipe control rechargeable delay circuit



    Top