touch sensor switch using inverters


Posted on Feb 6, 2014

This touch sensor switch can is designed using inverters (N1, N2)and some common electronic components. In standby state at the entrances of N1 there is a signal produced by oscillator N3/N4. At the touch sensor hand capacity forms a bridge to the ground for the 1MHz signal so that the voltage signal at the entrance of N1 decreases more (at the ex


touch sensor switch using inverters
Click here to download the full size of the above Circuit.

it of N2 is logical 1). After the release of contact, a signal charge C4 through D1 Mhz, so the output of N2 is 0 logic after short time.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Intruder Alarm
    darkroom timer with PIC 16F84A
    VCO with NE567
    3 square waves generator
    Timer
    3A Dc-Dc Converter Needs No Heatsink Circuit
    Arduino V-USB / HID 14 channel data logger
    LED Hat Display with Pong using an Arduino
    Duplexing wireless series transmission scheme of the one-chip computer
    Schematic 2.1 Channel Systems-Dual Power Amplifier TDA7240 and TDA1517Circuits
    Summing CT Measurements
    Simple audio amplifier LM307 A741



    Top