Ponyprog for AVR & PIC16F84


Posted on Feb 18, 2013

All resistors are 1/4W.The circuit is powered by 9...15V DC or AC. When In Circuit Programming (ISP) connectors are used, is possible the programmer to be powered from target?s power source. Diodes D2 and D6 protect the regulator LM7805, when target?s power is used. ?PIC JUMP? is used to switch between Microchip?s PIC and ATMEL?s microcontrollers. With jumper ON only PIC can be programmed, while OFF can program ATMEL?s microcontrollers. If you don?t need to program PICs, you can leave their board area unsoldered. The PCB has been designed so that DIP sockets or ZIF sockets can be used. Because of its cost, it is recommended that only one ZIF is used combined with some pin-arrays to switch between the four different places.


Ponyprog for AVR & PIC16F84
Click here to download the full size of the above Circuit.

ATtiny12, ATtiny15, AT90S1200, AT90S1200A, AT90S2233, AT90S2313, AT90S2323, AT90S2343, AT90S4414, AT90S4433, AT90S4434, AT90S8515, AT90S8535, ATmega8, ATmega16, ATmega161, ATmega163, ATmega323, ATMEL?s 8051 series, AT89S53, AT89S8252 MICROCHIP?s PIC series PIC16x83, PIC16x84, PIC16F84A And some other programmable ICs (memories, microcontrollers) which Ponyprog support but need a board adapter to be programmed through ISP connectors. For more information see Claudio Lanconelli site .




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Breath-alert-alcohol-tester
Simple Solar Table Lamp Circuit for your Home
1KHz IR transmitter circuit
2 module ir light barrier wont run same power source
How To Build A Simple Keypad Switch With A Tamper Alarm
IN8510 and power motor driver circuit composed of DAC7520



Top