Pinout Of The Fa-6
The FA-6 synthesizer features an 8-pin DIN connector that serves multiple functions, including audio input/output and remote control capabilities. To effectively interface a tape recorder with this synthesizer, it is essential to understand the pinout configuration of the DIN connector.
The standard pinout for an 8-pin DIN connector is as follows:
1. Pin 1: Ground (common return for audio signals)
2. Pin 2: Line Out (audio output to tape recorder)
3. Pin 3: Line In (audio input from tape recorder)
4. Pin 4: Remote Control (for play/stop commands)
5. Pin 5: Not used (typically left unconnected)
6. Pin 6: Not used (typically left unconnected)
7. Pin 7: +5V DC (optional power supply for remote devices)
8. Pin 8: Shield (for grounding and noise reduction)
To connect the FA-6 to a tape recorder, the user should connect the tape recorder's line out to pin 2 of the FA-6's DIN connector, and the line in of the tape recorder to pin 3. The remote control functionality can be utilized by connecting the relevant control signals to pin 4, facilitating remote operation of the tape recorder during playback or recording.
It is crucial to ensure that the tape recorder is compatible with the signal levels and formats used by the FA-6 to avoid any potential damage to the equipment or degradation of audio quality. Proper shielding and grounding practices should also be applied to minimize noise interference during operation.
This pinout configuration enables seamless integration between the FA-6 synthesizer and a standard tape recorder, allowing for efficient saving and loading of programs.Pinout Of The Fa-6 - posted in General Discussion: Hello I am new at this Forum and hope that I will do nothing wrong. My question is how to connect aTape Recorder with ""line in"", ""line out"" and ""remote"" to my new FA-6.
On the FA-6 is a 8 Din plug but I can`t connect Din to my Tape Recorde I would need the pinout from this 8 Din plug that I can connect to, save and load my prg., to my normal Tape Recorder. Do anybody have a descrtion from this 8 Din plug. 🔗 External reference
Related Circuits
The IEEE-1284 bus specifies a parallel printer bus with data transfer speeds exceeding 1 MBps. It defines a point-to-point asynchronous bi-directional interface. Devices can be either 1284 compatible (older parallel port devices) or 1284 compliant. The maximum recommended length...
The Altera USB-Blaster is an effective USB JTAG programmer, with clones available for US$10 or less. It includes a detailed manual that features a pinout diagram for the JTAG device side. However, the diagram lacks orientation details. A polarization...
It is essential to implement current limiting when charging batteries. Open frame linear power supplies can be used for this purpose, with the current limit set to the recommended charging current of the battery. Foldback current limiting is particularly...
Pinout of a smart card (SIM card) to PC adapter cable (SIM reader/writer) schematic and layout of a 6-pin SIM card special connector and a 9-pin D-SUB female connector used to connect computers to ISO 7816 compatible chip card...
The schematic presented illustrates a 5A H-Bridge Module designed for the operation of a single Bipolar DC motor. The H-Bridge Module includes a header set (J2) and a connector terminal set (J1). Below is the pinout description for the...
The pinout of the OBD-2 ISO 14230-4 (ISO-9141-2, KWP2000) RS-232 cable schematic and layout pertains to a 16-pin car OBD2 special connector. This connector is compatible with vehicles from most European and Asian manufacturers, including brands such as Alfa...