UPS Power Supply


Posted on Feb 3, 2013

This circuit is a simple form of the commercial UPS, the circuit provides a constant regulated 5 Volt output and an unregulated 12 Volt supply. In the event of electrical supply line failure the battery takes over, with no spikes on the regulated supply. This circuit can be adapted for other regulated and unregulated voltages by using different regulators and batteries. For a 15 Volt regulated supply use two 12 Volt batteries in series and a 7815 regulator. There is a lot of flexibility in this circuit.


UPS Power Supply
Click here to download the full size of the above Circuit.

TR1 has a primary matched to the local electrical supply which is 240 Volts in the UK. The secondary winding should be rated at least 12 Volts at 2 amp, but can be higher, for example 15 Volts. FS1 is a slow blow type and protects against short circuits o




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Car Battery Tester For Cranking Amps Circuit
    DS1621 IIC interface under Linux drives designing
    Scheme research and design of the ultrasonic range measurement system
    1Hz Oscillator circuit
    dev board
    PLL Synthesizer for 150 MHz Local Oscillator
    laser security system
    ZX Interface 2
    Advanced Projects in Laser Communication
    KB0PS ILink Station
    Having 50 input output impedance wideband video amplifier OPA676 circuit
    XTR112 114 bridge input current excitation circuit diagram
    Schematic circuit diagram of low voltage and low voltage automatic conversion



    Top