Replacing heater block on fog machine

The heater block of the smoke machine is broken and has been replaced with a new one. However, the old heater block was removed a long time ago, and the connections for the cables are unclear. A picture of the smoke machine has been attached for assistance. The new heater block differs from the old one in that it does not have crimp terminals for the power supply.

The smoke machine operates by generating vapor using a heater block, which is an essential component for the device's functionality. In this case, the replacement heater block requires careful attention to the wiring connections to ensure proper operation. Typically, heater blocks have specific terminals for power supply connections, which may include positive and negative terminals, as well as additional connections for temperature sensors or safety cut-offs.

To facilitate the installation of the new heater block, it is important to reference the manufacturer's specifications for the smoke machine model in question. This documentation may provide a wiring diagram or pinout that outlines the correct connections for the power supply and any additional components. If the new heater block lacks crimp terminals, alternative connection methods such as soldering or using screw terminals may be necessary.

When connecting the wires, ensure that the power supply is disconnected to prevent any electrical hazards. Identify the positive and negative leads from the power supply and match them to the corresponding terminals on the new heater block. It may also be beneficial to check for any additional connectors that may be present, such as those for a thermal switch or a fan, if applicable.

Once all connections are made, double-check for secure connections and proper insulation to avoid short circuits. After confirming that everything is correctly wired, power the smoke machine on and monitor its operation to ensure that the new heater block is functioning as intended. If issues arise, further troubleshooting may be required, which could involve checking for continuity in the wiring or testing the heater block's resistance.My smoke machine heater block has broken so I bought a new one, however I removed the old heater block ages ago and I cant remember what cables go where, I have attached a picture of my smoke machine in hope that someone can help me. The only difference between this heater block and the old one is that this heater doesn`t have crimp terminals for the power supply where as the old one did.

Thanks. 🔗 External reference