Water Activated Alarm circuit


Posted on Mar 28, 2007

The circuit uses a 555 timer wired as an astable oscillator and powered by the emitter current of the BC109C. Under dry conditions, the transistor will have no bias current and be fully off. However as the probes get wet the transistor will conduct and sounding


Water Activated Alarm circuit
Click here to download the full size of the above Circuit.

the alarm.An On / Off switch is provided and remember to use a non-reactive metal for the probe contacts. Gold or silver plated contacts from an old relay may be used, however a cheap alternative is to wire alternate copper strips from a piece of veroboard. These will eventually oxidize over but as very little current is flowing in the base circuit, the higher impedance caused by oxidization is not important. No base resistor is necessary as the transistor is in emitter follower, current limit being the impedance at the emitter (the oscillator circuit).




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Active Antenna
Delay circuit for a long time periods ( 4060 )
220V LED Flasher
Simple condenser microphone circuit Schematic Diagram
Poddwatt: Class-A Stereo Push-Pull EL84 (6BQ5) Vacuum Tube Amplifier
Portable Solar Powered Lantern Circuit
Butler Oscillator
State Variable Oscillator
Tape monitor the direction of movement
A six thyristor AC switch circuits



Top