Adjustable Strobe Light


Posted on Jun 27, 2012

This Adjustable Strobe Light is the bigger brother of the plain old strobe light. This one uses a much more powerful `horse shoe` Xenon tube which produces more light. You can also control the flash rate up to about 20Hz. Do not look directly at the flash tube when this thing is on! # T1 and L1 are available from The Electronics Goldmine (see Where To Get Parts). This ciruits is NOT isolated from ground. Use caution when operating without a case. A case is required for normal operation. Do not touch any part of the circuit with the case open or not installed. Most any diodes rated at greater then 250 volts at 1 amp can be used instead of the 1N4004`s. Do not operate this circuit at high flash rates for more than about 30 seconds or else C1 and C2 will overheat and explode. There is no on/off switch in the schematic, but you can of course add one.


Adjustable Strobe Light
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Shunt Regulator for Solar Cells
Double IC For Circuit an Infrared Toy Car Motor Controller
6V to 220V inverter schematic Schematic Diagram
joule thief
30 watt audio amplifier
Low pass filter circuit 10KHz using uA741
Audio Mixer
Inexpensive frequency counter tachometer
Based on the LT3755 50W white LED headlight drive circuit diagram
OP27 multiple S-type thermocouple circuit



Top