BEAM pummer circuits


Posted on Aug 6, 2012

The PowerSaver Flasher uses capacitive output coupling to produce brighter shorter flashes and has a much lower average current drain than standard bicore or 74HC14 flashers. The PS Flasher with one LED circuit (2 LEDs) runs all night from a 1F capacitor charged to 5.5V. Up to 12 LEDs can be controlled with one 74HC14 flasher and probably would run for 2 hours from a full charge. Use a range of timing resistors between 1M and 4.7M for each oscillator to give a random light show appearance.


BEAM pummer circuits
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Controlling stepper motors
Tape recorder position indicator-controller
Sun-tracker
Electronic-music
Three-Decade 15Hz To 15Khz Wien-Bridge Oscillator
Arduino Audio DAC Options
Digital Remote Thermometer
Switch Timer For Bathroom Light
1MHZ Digital Frequency Meter
20dB VHF Amplifiers
Motion Detector with PIR Sensor
OP AMP SINE WAVE GENERATOR CIRCUIT



Top